What size filter is on an Intex 10×30 pool?
Table of Contents
What size filter is on an Intex 10×30 pool?
Measuring 3 5/8 inches x 4 inches, this Type H filter fits Intex brand model number pumps 28601 and 28602 for 330 gallons per hour.
How long does it take to fill a 10ft Intex pool?
between 3 and 4 hours
Takes a while to fill between 3 and 4 hours. The pump is on the lean side and although it filters the water the filter seems in drastically reduce the flow and can at times choke itself. We added in an ‘intex’ solar heater for the pool, which warms the water by 5 or 6 degrees.
How many gallons of water are in a 10ft Intex pool?
Pump voltage: 220-240V. Pool water capacity at 80% full: 848 gallons (3,853 litres). Size: Diameter 10 feet (305cm), Height 30 inches (76cm)….SKU.
| SKU | 28122 |
|---|---|
| Diameter | 3 m / 10 ft |
| Depth | 0.76 m / 2.5 ft |
| Capacity | 3,853 L / 848 gal |
| Filtration & Pump Type | Intex filter pump – flow rate 1,250 L / 275 gal |
How much does it cost to fill Intex pool?
Intex Frequently Asked Questions
| FREQUENTLY ASKED QUESTIONS | |
|---|---|
| EASY SET POOLS | |
| Answer : | Up to the fill line which is approximately 80% full. |
| Question : | How high is the pool? |
| Answer : | The 10′ and 12′ pools are 30″ high and the 15′ pool is 36″ high. |
How long can you leave water in Intex pool?
Run your filter pump for at least 12 hours a day, every day. This will make sure all the water in your pool circulates at least once. In an ideal world of bottomless money vaults, you could run your pool pump 24 hours a day, but 12 hours is a good compromise.
Do I need to add chlorine to my Intex pool?
For the greatest protection against algae, bacteria, and cloudy water, Intex pools should maintain a chlorine level of 2.0-4.0 ppm at all times. If you opted for the Intex Salt Chlorinator, you can make your own chlorine by adding the correct amount of Pool Salt to the water.
Do I need to put chlorine in Intex pool?
Do I need to shock my Intex pool?
We recommend shocking Intex pools every week, especially if you’re having a heat wave or heavy rains. Heat and excess water can knock your chlorine levels to sub-par levels pretty quickly. Use a pool shock with a decent amount of available chlorine, and run your filtration system after you shock your pool.
What should I put around my Intex pool?
How to install a simple, above-ground pool perimeter:
- Apply landscaping fabric around the perimeter.
- Install a border or edging against the pool wall to keep rocks, mulch, or debris from reaching underneath the pool wall.
- Place mulch or rocks on top of the landscape fabric.
Can I put bleach in my pool?
Bleach, like any other kind of pool treatment, is best used in specific concentrations — that is, you’ll want to be able to detect a certain amount of chlorine in your pool water. Too little, and you won’t effectively sanitize your pool water and surfaces. Too much, and your pool water might become too harsh to use.
How long after you shock a pool Can you swim?
24 hours
After you shock the pool — As soon as your chlorine levels reach 5 ppm or lower, it’s officially safe to swim. Depending on the type of shock used, as well as the amount used, it can take anywhere from 24 hours or even up to a couple of days.
