How do you clean the lint trap on a Maytag Bravos dryer?
Table of Contents
How do you clean the lint trap on a Maytag Bravos dryer?
To wash:
- Roll lint off the screen with your fingers.
- Wet both sides of the lint screen with hot water.
- Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.
- Rinse screen with hot water.
- Thoroughly dry the lint screen with a clean towel.
Why does my dryer keep saying check lint screen?
The control panel has an indicator light “Check Lint” or “Check Lint Screen” to remind you to clean the lint screen before each load. It is normal for the light to be on or flashing before the cycle starts. The indicator light will turn off once the door is opened or a cycle is started.
Does a Maytag dryer have a filter?
Popular Maytag Dryer Filters. The filter collects lint during the drying cycle. This filter is 12 1/2 inches wide and 10 1/2 inches deep. Replacing the lint filter is an easy repair which requires no tools.
Where is Maytag dryer lint trap?
This Maytag lint trap is located in the front of the dryer drum below the door. This lint screen measures about 12 1/2 inches wide by 9 7/8 inches high.
Why does my dryer keep saying clean lint filter?
Some dryers with electronic controls have a “Clean Filter” reminder that appears after each cycle is finished and will stay on the display until the next load is run. This is a reminder message (not sensor based) and appears on the display even if the lint filter has been cleaned. It cannot be disabled.
How do I clean the sensor on my Maytag dryer?
Cleaning Your Maytag Dryer Moisture Sensor
- Locate dryer moisture sensor. It’s typically found on the back wall of the dryer drum or in the front near the lint trap.
- Use fine grit sandpaper to scrub the moisture sensor.
- Use a dry rag to polish up moisture sensor.
- Test dryer.
What do you do when your dryer says check filter?
A check filter light means that before your next drying cycle, you should remove any excess lint from the lint filter and lint chute area.
Does Maytag Bravos have a lint filter?
1 Answer. Hi, There is no mention of a lint filter, in the owner manual. However there is a drain pump filter, part #14 Basket and tub parts diagram mentioned in the parts list, which is there to trap lint from being pumped out to the drain.
Does my Maytag washer have a lint filter?
All modern Maytag washers have filters that should be regularly cleaned every 3-6 months to prevent harmful lint buildup or clogs. In top-loading machines the filters are in the center of the agitator tube.
Where is the drain filter on a Maytag Bravos washer?
Open the dispenser drawer by pulling on the handle at the base of the washer. This will reveal the drain pump filter. Remove the drawer by releasing the tab on each side. With your finger, push down on tab on right side of drawer, and up on tab on left side of drawer.
