How do I register my DSC keypad?

How do I register my DSC keypad?

Enroll the keypad. Press [*] + [8] + [Installer Code] + [902] to access the appropriate menu. Remember that the default Installer Code is 5555. Then enter [000] to have any connected keypads auto-enrolled. If you wired the keypad successfully, then it should auto-enroll.

How do you assign a keypad zone on a DSC?

1. Step 1 – Keypad Assignment. To use keypad zones, each keypad must be assigned to its own slot (1 to 8).
2. Step 2 – Keypad Zone Definition. Zones must be defined before they will operate.
3. Step 3 – Keypad Zone Assignment.
4. Step 4 –Zone Assignment – Zones 1 – 8.
5. Step 5 – Enable Keypad Zone.

How do you broadcast labels on DSC keypad?

Perform the following procedure in order to broad- cast labels: Step 1 – Program one LCD keypad completely. Step 2 – Make sure all LCD keypads are connected to the Keybus. Step 3 – Enter keypad programming by pressing [,][8][Installer Code][,], then enter section [998] at the keypad that was programmed.

How do I register my DSC neo wireless keypad?

How do I enroll additional DSC NEO keypads?

1. Make sure all keypads that you are wanting to enroll are wired properly to the CORBUS.
2. On the first keypad that is already enrolled, enter programming with *8 followed by the installer code.
3. Enter section number 902.
4. The keypad should already be on subsection 000 so press *.

How do you program zones on a DSC 1832?

How do I program a wireless zone on the DSC 1616, 1832, and 1864 systems?

1. Enter section 898.
2. You will now trip the first wireless device that you want to add.
3. Check that the ESN on the device and the keypad match and then press *.
4. You will now need to enter a zone number.
5. Then the system will ask for a zone type.

How do I register a second keypad DSC Neo?

How do I install a DSC wireless keypad?

Complete the following steps to add an external keypad to a DSC Impassa:

1. Activate wireless enrollment mode. With the DSC Impassa powered on and disarmed, enter in the command [*][8] [Installer Code] [898].
2. Activate the enrollment function. Plug in the keypad to turn it on.
3. Verify enrollment.

How do I program a DSC wireless device?

How do I program a wireless zone on a DSC NEO?

1. Use *8-installer code to go into programming mode.
2. Enter section 804 to go to wireless programming.
3. Enter 000 to go to enroll devices.
4. Press and hold the enroll button on your PowerG device.
5. The keypad should display the device’s serial number.