How do I pair my iLO serial port?
Table of Contents
How do I pair my iLO serial port?
Configuring the iLO virtual serial port in the host system RBSU
- Optional: If user access the server remotely, start an iLO remote console session.
- Restart or power on the server.
- Press F9 in the HP ProLiant POST screen.
- Select System Options, and then press Enter.
- Select Serial Port Options, and then press Enter.
How do I enable iLO port?
Press F9 in the server POST screen. The UEFI system utilities start. Click System Configuration. Click iLO 5 Configuration utility….
- Start the iLO remote console.
- Press ESC several times to navigate to the System Configuration page.
What is UUID in iLO?
UUID – The universally unique identifier that software (for example, HP SIM) uses to uniquelyidentify this host. This value is assigned when the system is manufactured.
How do I access iLO via SSH?
Open a browser software, enter the IP address of your iLO interface and access the web interface.
- On the prompt screen, enter the administrative login information.
- After a successful login, the administrative menu will be displayed.
- On the Access Settings tab, enable the SSH service and click on the Apply button.
How does iLO port work?
iLO dedicated network port – Uses an independent NIC that is dedicated to iLO network traffic only. When supported, this port uses an RJ-45 jack (labeled iLO) on the back of the server. Shared network port LOM – Uses a permanently installed NIC that is built into the server.
How do I connect to iLO directly?
Procedure
- Connect an Ethernet cable from the Ethernet port on the laptop to the iLO Ethernet port on the rear of the server.
- If necessary, change the IPv4 address of the Ethernet port on user’s Windows laptop:
- Use the default user name and password found on the label attached to the top of the chassis to log in.
How do I know my iLO port?
Navigate to the Network, iLO Dedicated Network Port page. Click the General tab. Select the Use iLO Dedicated Network Port check box.
How do I find the iLO port on my HP server?
Just look on the back of the server, you should see a network port marked “iLO” or “iLO 2”, make sure that port is plugged in to a network switch.
How do I connect to iLO CLI?
On iLO 3 command line interface can be accessed via SSH or serial port. Up to five network connections can be active simultaneously. Note: in case of serial port connection CLI is enabled by hitting ESC. The SSH session starts after authentication.
How do I check my iLO status?
To access the Status Summary page from other areas ofthe iLO 2 interface, click System Status>Summary. Server Name – Displays the name of the server and is a link to Administration>Options>Access. UUID – Displays the ID of the server.
Can I use iLO port for network?
Only one of the Dedicated network port or shared network port options can be enabled at a time because iLO supports only one active NIC connection. By default, the iLO shared network port uses port 1 on the server NIC. Depending on the server configuration, this NIC might be a LOM or FlexibleLOM adapter.
Can I use iLO port as Nic?
Configuring NIC settings Enable the iLO dedicated network port or the iLO shared network port and configure the associated NIC settings in the NIC settings section of the network general settings tab. Connect the iLO Dedicated Network Port to a LAN from which the server is managed.
How do I find the IP address of my iLO port?
you can go into System Management Homepage-> Management processor link, then when you click it on the left from the task pane you must be forwarded to a link for iLO and you can see the IP address.
