What is nominal timber size?

What is nominal timber size?

Lumber sizes are usually given in “nominal” measurements. The nominal measurements are a board’s size before it has been planed smooth (surfaced) on all 4 sides. The actual measurements are the final size. If your project calls for precise measurements, be sure to check your lumber before purchasing.

What are the standard sizes of wood?

The most commonly used lumber, structural lumber, are the 2-foot x 4-foot and 4-foot x 4-foot boards used in everyday DIY and construction projects. Framing and structural lumber follows standard building dimensions (thickness and width).

What are the nominal sizes into which lumber is cut?

Lumber can be referred to by its nominal size in inches, which means the actual size rounded up to the nearest inch or by its actual size in millimeters. For instance, 38 × 89 mm (1-1/2 × 3-1/2 in) material is referred to nominally as 2 × 4 lumber.

When did lumber go to nominal size?

Early concepts called for rough lumber to be of full nominal size, often in the dry condition. After World War I, the increasing demand for construction lumber led to the first national size standard in 1924. This was revised in 1926, 1928, 1939, and 1953, while still another revision is proposed for adoption in 1964.

Why are lumber nominal and actual sizes different?

The “nominal” cross-section dimensions of a piece of lumber, such as 2 X 4 or 1 X 6, are always somewhat larger than the actual, or dressed, dimensions. The reason is that dressed lumber has been surfaced or planed smooth on four sides (called S4S). The nominal measurement is made before the lumber is surfaced.

What is the difference between nominal size and actual size?

Nominal size is the size you see printed on the side of your air filter. It stems from the actual size, which is rounded up to the nearest whole inch.

What is nominal size?

What do they call a 2×4 in Europe?

If you go to a lumberyard, you buy 48×98 as everything is measured in metric, but in the daily speach most people still use the term 2×4, 2×8 aso. The Inch measurement is in use as long as we speak about size on TV(40″) and cartyres (15″). When I fix my japanese car and the 16mm spanner is to big I grab the 15mm.

Why did 2×4 get smaller?

The simple reason why 2×4 is not 2 inches by 4 inches is that lumber mills trim off rough or warped surfaces of a 2×4 to give it a more polished and finished look. By planning the lumber on all four sides, the original 2×4 is now reduced to 1 ½ inches by 3 1/2 inches.

Why do they call it a 2 by 4?

DIMENSIONAL LUMBER: In the past, when a timber was called a 2×4 [or “two-by-four”], it actually measured 2 inches by 4 inches. Now, most timber is milled and planed to give it a little more of a finished look, and a little more of a consistent size and profile.