Is pultec EQ good?
Table of Contents
Is pultec EQ good?
Pultec-type EQs are great for shaping tones in a very natural way. It is difficult to get a bad-sounding result out of them. Even when frequencies are fully boosted, the boost still has a smooth and natural character about it. The reason for this are the Pultecs broad EQ curves.
What is the pultec trick?
This trick has become known as the ‘low-end trick’. On a bass drum, for example, if 30Hz is simultaneously boosted and cut, the curve created gives a boost at 80Hz with a dip at around 200 Hz – a very pleasing curve on some bass drums. The sound can be sweetened further using the high-frequency controls.
What is attenuation on EQ?
[ə‚ten·yə′wā·shən ′ē·kwə‚līz·ər] (electronics) Corrective network which is designed to make the absolute value of the transfer impedance, with respect to two chosen pairs of terminals, substantially constant for all frequencies within a desired range. Also known as attenuation factor.
Who makes pultec EQ?
Pultec EQP-1A Tube Program Equalizer | Sweetwater.
What CPS pultec?
The low-band frequency choices on Pultec EQs (CPS stands for cycles per second. 1 CPS is equivalent to 1Hz). For example, even if you set the low band for 30Hz, the shelf is so broad that it impacts up to the 1000Hz area. Likewise, the high band affects frequencies down to the lower midrange.
What does attenuation mean in music?
Acoustic attenuation is a measure of the energy loss of sound propagation in media. Most media have viscosity and are therefore not ideal media. When sound propagates in such media, there is always thermal consumption of energy caused by viscosity.
What does a parametric EQ do?
The parametric EQ is a mainstay of recording and live sound because it offers continuous control over every parameter. A parametric equalizer offers continuous control over the audio signal’s frequency content, which is divided into several bands of frequencies (most commonly three to seven bands).
What does a sound attenuator do?
A sound attenuator, or duct silencer, sound trap, or muffler, is a noise control acoustical treatment of Heating Ventilating and Air-Conditioning (HVAC) ductwork designed to reduce transmission of noise through the ductwork, either from equipment into occupied spaces in a building, or between occupied spaces.
How do you mix lead vocals?
Here’s an easy way to find the best settings:
- Start with the slowest attack and fastest release times.
- Slowly increase the attack time until you start to shave off the initial transient of the vocal, then back off.
- Next, slowly decrease the release time until the compressor starts to “breathe” in time with the song.
What is a parametric equalizer used for?
A parametric equalizer lets you control three aspects: level (boosting or cutting decibels), the exact frequency, and the bandwidth or range (also known as Q or quotient of change) of each frequency. As such, parametric equalizers offer surgical precision when it comes to affecting the overall sound.
