How do I clear my HP router settings?

How do I clear my HP router settings?

Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch. The power and fault lights come on. Continue to press the Clear button while releasing the Reset button.

What is the command to reset the switch?

1. Reset the switch to factory defaults: Erase the existing configuration:
2. Save the configuration: IP_switch-A-1# copy running-config startup-config.
3. Reboot the switch and wait for the switch to reload: IP_switch-A-1# reload.
4. Repeat the previous steps on the other three switches in the MetroCluster IP configuration.

How do I factory reset my HP 2920?

To execute the factory default reset on the switch, perform these steps:

1. Using pointed objects, simultaneously press both the Reset and Clearbuttons on the front of the switch.
2. Continue to press the Clear button while releasing the Reset button. When the Test LED begins to blink, release the Clear button.

How do I access my HP Router?

Type 192.168. 1.1 (the most common IP for HP routers) in the address bar of your web browser to access the router’s web-based user interface. You should see 2 text fields where you can enter a username and a password. The default username for your HP router is admin.

How do I reset my HP ProCurve 5406zl?

When resetting a Switch 5412zl, 5406zl, 3500yl-24G, or 3500yl-48G to factory default settings, the “Clear” button must be depressed for approximately 25 seconds. For all other switches, the Clear Button is held for no more than 5 seconds. Release the Clear button.

How do I reset my HP 1920 switch?

To execute the factory default reset on the switch, perform these steps:

1. Using a small, thin tool with blunt ends (such as a paper clip), press the Reset button on the front of the switch.
2. Continue to press the Reset button until the Fault LED light begins to flash.
3. Release the Reset button.

How do I factory Reset my HP 2920?

How do I Reset my HP switch password?

HP E5500-24G-SFP Switch – Password Recovery

1. Press Ctrl-B to enter Boot Menu…
2. Before the countdown reaches 0 enter B.
3. The timer is followed by a password prompt. The default is no password.
4. Press Enter to display the following boot menu:

What is the default admin password for HP laptop?

The default administrator or root password for all HP-provided Build Plans is: ChangeMe123! CAUTION: HP strongly recommends changing this password before deploying to any servers.

How do I setup my HP ProCurve switch?

How to: Configure a HP ProCurve switch

1. Step 1: Connect your serial connection.
2. Step 2: Conenct PuTTY.
3. Step 3: Get the IP address.
4. Step 4: Set time server.
5. Step 5: Set SNMP community info.
6. Step 6: Launch the web GUI.
7. Step 7: Configure basic info.
8. Step 8: Create VLANs.