How do I reset my juniper switch to factory settings?

How do I reset my juniper switch to factory settings?

To restore the switch to the default factory configuration:

1. Make sure you are in configuration mode.
2. Enter the following commands at the CLI: [edit] user@switch# load factory-default [edit] user@switch# delete system commit factory-settings [edit] user@switch# commit. Note:

How do I reboot my Junos?

Use the request vmhost reboot command instead of the request system reboot command on the PTX10008 and PTX10016 routers to reboot the Junos OS software package or bundle on the router.

How do I delete all configuration in Juniper switch?

To remove any config from the switch we need to append ‘delete’ for any command that needs to be deleted. EX: delete system ntp server 192.168. 3.65. As seen from below screenshot we have ‘set’ and ‘delete’ commands.

How do I reset the root password on a juniper EX2200?

9. RE: Unable to reset password on EX2200

1. Obtain console access.
2. Power off the system and boot it up in single user mode.
3. Next, the system will run the normal bootup process.
4. The system will finish booting up and display the root>prompt.
5. Enter configuration mode and edit or delete the root authentication password.

How do I reset my juniper ex2300 to factory settings?

To revert to the factory-default configuration by using the LCD panel:

1. Press the Menu button until you see MAINTENANCE MENU on the panel.
2. Press the Enter button.
3. Press Menu until you see FACTORY DEFAULT.
4. Press Enter. The display says RESTORE DEFAULT?
5. Press Enter.
6. Complete the initial configuration of the switch.

How do I factory reset my SRX?

You can use the Reset Config button on the front panel of the SRX device to reset the device to its factory default configuration. The Reset Config button is recessed to prevent it from being pressed accidentally; so you need to insert a small probe (for example, a straightened paper clip) to press the button.

How do I recover my root password?

In some situations, you may need to access an account for which you’ve lost or forgotten a password.

1. Step 1: Boot to Recovery Mode. Restart your system.
2. Step 2: Drop Out to Root Shell.
3. Step 3: Remount the File System with Write-Permissions.
4. Step 4: Change the Password.

How do you break a Juniper switch password?

At the following prompt, type boot -s to start the system in single-user mode. At the following prompt, type recovery to start the root password recovery procedure. Enter configuration mode in the CLI….Configure the port settings as follows:

1. Bits per second: 9600.
2. Data bits: 8.
3. Parity: None.
4. Stop bits: 1.
5. Flow control: None.

How do I delete all configurations in Juniper?

How do you reset a Juniper EX switch?

To restart the switch from the front panel:

1. From the LCD front panel menu push the Menu button.
2. When the MAIN MENU (Maintenance menu) appears, press the Enter button.
3. Select the SYSTEM REBOOT option and press the Enter button.
4. To exit the menu without rebooting the switch, press the Menu button again.