How do I reset my HP OfficeJet Pro 8500?
Table of Contents
How do I reset my HP OfficeJet Pro 8500?
Please try:
- Turn the printer off with the front panel button.
- Disconnect the power cord from the product, and then wait 20 seconds.
- Press and hold # and 6 (or 9) while reconnecting the power cord.
- Wait 10 seconds, and then release both buttons. The product resets and prints an alignment page.
Where is the duplex switch on HP printer?
Right-click the printer icon ( ) for your HP product. Click Properties, and then click the Device Settings tab. Click the plus sign (+) next to Installable Options to expand the list. Click Duplex Unit (for two-sided printing), and then select Installed from the drop-down list.
Why won’t my HP printer scan the alignment page?
Check the cartridges for debris, and then make sure the nozzles and electrical contacts are not covered by protective tape. Reinsert the cartridges in the correct slots. Close the ink cartridge access door. Wait until the alignment page prints, and then follow any prompts to scan it and complete the alignment process.
How do I reset my HP printer alignment?
With the printer turned on, disconnect the power cord from the rear of the printer. Unplug the power cord from the wall outlet. Wait at least 60 seconds. Plug the power cord back into the wall outlet.
How do I check my HP printer firmware?
Go to HP Software and Driver Downloads, and then enter your printer model. Select Firmware from the list of drivers, click Download next to the update, and then follow the instructions. Note: If you do not see a firmware option, there are no firmware updates for your printer.
How do I scan front and back on the same page HP?
HP Scanjet 8270 Scanner – Scan Two-Sided Originals
- Place a stack of similarly sized pages face-up in the input tray of the ADF, with the first page on top.
- Adjust the paper guides to center the stack.
- Slide the Duplex switch located near the ADF to the left.
- Open HP Solution Center.
- Click Scan Document.
- Click Scan.
