Why is my washer not spinning during spin cycle?
Table of Contents
Why is my washer not spinning during spin cycle?
Normally, your washing machine won’t go into a spin cycle until it’s been drained. The drainage hose may become clogged with debris from your clothing, or it could be kinked. If the hose is kinked or crushed, it will likely need to be replaced.
How do I reset my Whirlpool washer that won’t spin?
How Do I Reset My Whirlpool Washing Machine?
- Turn off the washer.
- Turn the mode dial to NORMAL.
- Turn the dial counter-clockwise one click left, clockwise three clicks, counterclockwise one click, and then clockwise one click.
How do you fix a washer that will not spin?
- Redistribute an off-balanced load of laundry.
- Level an off-kilter washer.
- Check the power source.
- Stop using an extension cord.
- Inspect the spin switch.
- Stick to high efficiency detergent with a front-load washer.
- Undo any kink in the hose.
- Track down a blockage in the drainage system.
Why is my Whirlpool washer not draining or spinning?
If your washer won’t drain or spin, the water level control may be faulty. Open the machine’s control panel and look for a plastic tube attached to the water level valve. If it’s clogged, clear it out with vinegar. If the valve itself is corroded, it may need to be replaced.
How do I force my Whirlpool washer to drain?
Find the “Pause/Cancel” button on the control panel. Press this button twice to drain the washer. Press the “Power” button and rotate the cycle selection knob to “Drain and Spin” to remove the remaining water from the load. Check the washer’s discharge hose if the water fails to drain from the washtub.
How do I know if my Whirlpool drain pump is bad?
Put your finger into the drain outlet and feel the impellers if the pump freely turns. One or more of them may be broken. If so, you’ll be able to feel them while you’re turning the pump flywheel with your other hand. You also may see broken pieces of plastic in the bottom of the pump housing.
