How much does it cost to replace a CV joint on a Subaru?

How much does it cost to replace a CV joint on a Subaru?

Your car has multiple axle shafts, but in most cases, only one will need to be replaced….

Car 2015 Subaru OutbackH4-2.5L
Service Service typeAxle / CV Shaft Assembly – Driver Side Rear Replacement
Estimate Estimate$572.95
Shop/Dealer Price Shop/Dealer Price$698.34 – $1045.20

How much does it cost to replace both CV joints?

The Average Cost for Replacing a CV Axle Is $137 to $672 Depending on if You Go to the Mechanic or DIY. This price range is based on national averages for all vehicles and does not factor in taxes, fees, or your particular make and model.

Can you just replace the CV joint?

CV joints and boots can be replaced individually, but most professional technicians and even do-it-yourselfers prefer to replace the whole halfshaft assembly with a remanufactured shaft.

How long do Subaru CV axles last?

80,000 to 100,000 miles
A CV axle can typically be expected to last for 80,000 to 100,000 miles under normal driving conditions.

How can you tell when a CV joint is going bad?

These are the 5 easiest ways to identify if you have a damaged CV axle.

  1. A Tear in the Boot.
  2. Grease Found on the Inside of Your Wheels.
  3. Knocking Sound.
  4. Clicking While Turning.
  5. Vibration While Driving.

What happens if CV joints fail while driving?

If a CV joint begins to fail while driving, your car will start to pull to one side as one wheel loses power. When the joint breaks completely its corresponding wheel will no longer turn and although the engine may still run, the car won’t move.

Can you drive with a bad CV joint?

A severely worn out CV joint can even disintegrate while you’re driving and make the car undrivable. You may lose control of the vehicle entirely. It is not safe to drive with a damaged CV joint. Look for some symptoms of a failing CV joint to have it repaired before it becomes unsafe to operate the vehicle.

What causes a CV joint to go bad?

Why do CV joints break? The main culprit is shock loading, like when a spinning wheel lifts off the ground and then lands hard; something that can happen fairly often with an independent suspension system because of the usually limited amount of travel.

How urgent is a bad CV joint?

If CV joints fail, the effect is immediate and sometimes dangerous, since power will no longer transfer from the engine to the tires.

How do you tell which CV joint is bad?

To check for a noisy worn outer CV joint:

  1. Put the car in reverse. Then turn the steering wheel all the way to one side and drive backward in a circle.
  2. If you hear a very pronounced clicking or snapping noise, there’s a good chance an outer CV joint is worn out.

Can I drive my car with a bad CV joint?

How long can I drive with bad CV joints?

You can drive on a damaged CV joint for a little while, but there’s no telling how long “safe” operation will last. There are many factors, such as where you drive, the amount of dirt/dust/debris in the areas you drive, how much water gets into the joint, and more.

Can you still drive with a broken CV joint?

A boot seals the CV, and this boot is not resistant to damage. Whenever this happens, the joint will wear out and fail. If you drive a car with a damaged CV, the joint will deteriorate more, making driving impossible. You’ll be at risk of getting into an accident.

  • October 10, 2022