Articles

How do I change my Cisco access point password?

How do I change my Cisco access point password?

Cisco 3848V change password

  1. Visit the Admin Console by visiting 192.168.
  2. Log in with the following information:
  3. Click Login.
  4. Click Wireless at the top of the page.
  5. Click the Wireless Security tab.
  6. Under 2.4GHz Wireless Security, type a new password for the network in the Pre-Shared Key field.

What is the default enable password for a cisco 1200 series AP?

The default password is Cisco. The Summary Status page appears.

What is the default password for cisco Aironet AP?

After the access point rejoins a controller, it adopts the default Cisco/Cisco username and password.

What is the default IP address of a cisco 1200 series AP?

Type 10.10. 10.1 (the default IP to access the admin interface) in the address bar of your internet browser to access the router’s web-based user interface. You should see 2 text fields where you can enter a username and a password. The default username for your CISCO Aironet 1200 is Cisco.

How to configure a Cisco Access Point?

Configuring Universal Client Mode (optional)

  • Configuring Radio Data Rates on an Access Point (optional)
  • Configuring Radio and Client Device Power Levels on an Access Point (optional)
  • Configuring Radio Channel Settings on an Access Point (optional)
  • Configuring Dynamic Frequency Selection on an Access Point (optional)

    • How to reset the configuration in Cisco Access Point?

    Enter erase nvram: to erase all NVRAM files including the startup configuration. Note The erase nvram command does not erase a static IP address.

  • Follow the step below to erase a static IP address and subnet mask. Otherwise,go to step 3.
  • Enter Y when the following CLI message displays: Erasing the nvram filesystem will remove all configuration files!

    • How to configure Cisco Access Point in a bridge mode?

    Log in to the web-based utility of the WAPand choose Wireless > WorkGroup Bridge.

  • Check the Enable WorkGroup Bridge Mode check box. Note: If clustering is enabled on the WAP,a pop-up will notify you to disable clustering in order for the
  • Click the radio interface for the WorkGroup Bridge.

    • How do you install a Cisco Aironet 1200?

    Getting Started Guide for Cisco Aironet 1600 Series Access Points 11/Jul/2019

  • EU Directives 1999/5/EC&93/42/ECC — Compliance Information for the Cisco Aironet 1600 series IEEE802.11 a/b/g/n Wireless LAN Products 20/Nov/2012
  • Channels and Maximum Power Settings for Cisco 1600e and 1600i Series Access Points (XLSX – 424 KB) 20/Nov/2012
    • October 5, 2022

    You may also like...