How do you use EDFA?
Table of Contents
How do you use EDFA?
EDFAs are used as a booster, inline, and pre-amplifier in an optical transmission line, as schematically shown in Figure 2. The booster amplifier is placed just after the transmitter to increase the optical power launched to the transmission line.
What does EDFA stand for?
Erbium-doped fiber amplifier
Erbium-doped fiber amplifier (EDFA) is an optical repeater device that is used to boost the intensity of optical signals being carried through a fiber optic communications system.
What is EDFA and how it is used with DWDM?
The pre-amplifier is used to compensate for losses in a demultiplexer near the optical receiver. Placed before the receiver end of the DWDM link, pre-amplifier EDFA works to enhance the signal level before the photo detection takes place in an ultra-long haul system, hence improving the receive sensitivity.
What is EDFA in cable TV?
Erbium-Doped Fiber Amplifier (EDFA) carries cable TV (CATV) signals on optical distribution networks (ODNs) and transmits broadcast TV, PON voice, and broadband services to provide fiber to the home (FTTH) and CATV video services quickly.
Which wavelength is most suitable for pumping an EDFA?
An SOA is pumped optically, whereas the EDFA is pumped electrically. An SOA amplifies 1300 nm wavelength, whereas the EDFA amplifies 1550 nm.
What is EDFA and how it works write in very short?
In general, EDFA works on the principle of stimulating the emission of photons. With EDFA, an erbium-doped optical fiber at the core is pumped with light from laser diodes. This type of setup in telecom systems can help with fiber communications, for example, boosting the power of a data transmitter.
How EDFA can influence the output signal?
For example the pump signal power 1 w, the fiber inversion level increases with the EDFA length position between 50 m to 120 m, this shows if the fiber inversion level increases the output amplified signal also increases, that is an inversion level is depends upon the pump power and wavelength.
What is the working principle of EDFA?
What is EDFA and Raman?
Edfa uses the principle of stimulated radiation of EDF fiber to amplify the optical signal. Raman amplification uses the Raman effect to achieve energy conversion and amplify the optical signal.
What is ASE in EDFA?
ASE stands for Amplified Spontaneous Emission. Let’s explain it in two steps. 1. Spontaneous Emission. Spontaneous emission is the process by which an atom, molecule or nucleus in an excited state drops to a lower-energy state, resulting in the creation of a photon.
What is the gain of EDFA?
The EDFA is the basic building block of advanced WDM systems. It provides gain across a wide wavelength range of over 30 nm in either the C or L bands. It is bit rate independent for any current transmission rate.
What is EDFA and how it works write in short?
