What should toe be set at during alignment?
Table of Contents
What should toe be set at during alignment?
Typical toe-in specs vary from one-thirty-second to one-eighth-inch, depending on the vehicle. Check a service manual for your car’s acceptable range. The best tip-off to a toe problem is a saw-tooth wear pattern that’s equal on both front tires.
Can toe-in cause death wobble?
OTHER ITEMS THAT MIGHT CONTRIBUTE TO DEATH WOBBLE: Several other conditions can bring about a DW episode such as a toe-in or caster settings that are significantly off, worn out or loose front shocks that are not valving properly.
Does toe-in cause understeer?
Toe adjustments on the rear tires also have an effect on car handling. Toe-in on the rear creates understeer, which can help with cars that are oversteery on exit. The tradeoff is wear and heat in the rear tires. Toe-out on the rear is generally wrong, as you’re likely to get more oversteer on exit.
Can you have too much positive caster?
Vehicles with too much positive caster can be prone to understeer, so most modern vehicles don’t have a caster greater than 3 to 5 degrees. This is the ideal range to maximize straight line stability and still allow for comfortable turning.
What is the purpose of toe in and toe out?
A toe in alignment of the wheels can help to reduce over steer problems and can increase stability in vehicles that have front-wheel drives. Alternately, a toe out alignment can help to mitigate issues related to under steering and can improve the handling on a vehicle that has a rear-wheel drive.
What does too much negative caster do?
Negative caster results in lighter and easier steering but reduced stability when driving in a straight line. Vehicles with negative caster do not handle as well. What is this? A symptom of negative caster is a sloppy or loose-feeling steering wheel (which is lot less common than a hard to turn wheel).
Should caster be the same on both sides?
Caster is the angle of your vehicle’s steering pivot when looked at from the side. Your tire’s caster should be the same on both sides of the vehicle; if it’s not the same, then the vehicle will tend to pull to the side that is less positive. Toe is a measurement of how parallel your tires are to each other.
